NEW Design by me to make hands free orgasms easier to achieve. This one features two loops on the side that can be used to thread a cord or elastic through to hold it firmly against your body.

When using conductive rubber cock loops for stimming you generally only stimulate the dorsal nerves running along the top of the penis. The sensations generated are felt at the glans of the penis. Insulating the top part of a lower cock loop if it is around the cock and balls allows you to stim both the Dorsal and Perineal nerves leading to better sensations.

For more information about stimming these nerves, check out my Electrosex Penis Play Guide For Hands Free Orgasms.

However, if you do not own a 3D printer then I am offering a service where I will print one out for you and send it to you. Each cock loop insulator will be printed in my trademark YELLOW PLA. This insulator comes with 10"/25cm of 6mm conductive rubber tubing that takes 2mm plugs.

It will be dispatched un-painted but with 6mm conductive rubber tubing already fitted.

The inner hole size is 1mm larger than the CR tubing, this 6mm tubing is a good friction fit and you don't need the plastic locking clamp to keep it in place once fitted. Just slip it over your cock and tighten before plugging your 2mm plug into the CR.

Check Out The Instructions For This Electrode

I recommend that you paint it first though to seal the surfaces with a plastic paint such as Krylon Fusion For Plastic.

Note: This product is supplied as is and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings, the printed product will show some layer lines and require a light sanding.