This is my latest electrode, and it features 6mm conductive rubber arranged as a cock loop as well as a top arc of 4mm conductive rubber with three stainless balls to focus the sensations. Both conductive rubber loops take 2mm TENS-style pins.

Designed for intense penis play, the 6mm loop can be used as a common electrode in a tri-phase configuration leaving the 4mm loop to be paired with another electrode or just use it on one channel; the choice is yours.

Available in two sizes based on the circumference of your penis just under the glans. The 20cm/8" version will fit most, but the 30cm/12"XL version allows you plenty so that it can be trimmed for an exact fit.

Usually, cock loops are monopole electrodes, but this one is different. It is a bipolar design, and it should be fitted snugly under the glans of the penis with the top loop going right over your glans. Place the balls where you want the most sensations, and some guys place one on their meatus (pee hole).

For more information about stimming the nerves of the penis, check out my Electrosex Penis Play Guide For Hands Free Orgasms.

I have designed this 3D printable cock loop plate and its pin. The design is done, and it is freely available for download on my Gdrive, so if you have access to a 3D printer, you can make one yourself.

However, if you do not own a 3D printer then I am offering a service where I will print one out for you and send it to you. Each bipolar glans cock loop and pin will be printed to order in Yellow PLA.

It will be dispatched unpainted and unfinished, so you may need to give it a light sanding to remove any pieces of the support structure that is printed in place by the 3D printer. This takes no time at all and then it is ready for use.

The inner holes are sized for 6mm and 4mm CR tube size and it will be supplied with the 6mm CR fitted in place with the 4mm loop ready for assembly. If I ship them assembled then there is a chance of the 4mm CR being damaged in transit.

Check Out The Instructions For This Electrode

I recommend that you paint it first though to seal the surfaces with a plastic paint such as Krylon Fusion For Plastic in order to seal the surface.

Note: This product is supplied as is, and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings, the printed product will show some layer lines and require a light sanding.