This revised electrode design is based on the one supplied to me by Gyrator on my site's forum and I decided to take his design and produce a 3D printed version with his permission.

Now available in two sizes with either 20cm/8" of 6mm CR or 38cm/15" of 6mm CR.

Usually, cock loops are monopole electrodes but this one is different. It is a bipolar design and it should be fitted just under the glans of the penis with the centre electrode touching your frenulum (banjo string). It produces strong sensations that can be felt in the glans and throughout the groin.

For more information about stimming the nerves of the penis, check out my Electrosex Penis Play Guide For Hands Free Orgasms.

I have designed this basic 3D printable cock loop plate and pins.

However, if you do not own a 3D printer then I am offering a service where I will print one out for you and send it to you. Each bipolar cock loop plate and pins will be printed to order in Yellow PLA.

It will be dispatched un-painted and unfinished, so you may need to give it a light sanding to remove any pieces of the support structure that is printed in place by the 3D printer. This takes no time at all and then it is ready for use.

The inner holes are sized for 6mm and 4mm CR tube size.

Check Out The Instructions For This Electrode

I recommend that you paint it first though to seal the surfaces with a plastic paint such as Krylon Fusion For Plastic.

Quick Video Introduction To This Electrode

Note: This product is supplied as is and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings, the printed product will show some layer lines and require a light sanding.