NEW ABS Version Of This Popular Electrode

This is my latest electrode and it features 6mm conductive rubber arranged as a cock loop as well as a top arc of 4mm conductive rubber with three stainless balls to focus the sensations. Both conductive rubber loops take 2mm TENS style pins.

Designed for intense penis play, the 6mm loop can be used as a common electrode in a tri-phase configuration leaving the 4mm loop to be paired with another electrode or just use it on one channel, the choice is yours.

Usually, cock loops are monopole electrodes but this one is different. It is a bipolar design and it should be fitted snugly under the glans of the penis with the top loop going right over your glans. Place the balls where you want the most sensations and some guys place one on their meatus (pee hole).

For more information about stimming the nerves of the penis, check out my Electrosex Penis Play Guide For Hands Free Orgasms.

I have designed this 3D printable cock loop plate and its pin.

Each of these bipolar glans cock loop and pins will be printed to order in Yellow or Black ABS (think Lego Brick plastic).

It will be dispatched after being Acetone vapour smoothed a process that takes time and patience. However, it seals the surface of the prints and makes them incredibly strong as well as non-porous so no finishing is required.

The inner holes are sized for 6mm and 4mm CR tube size and it will be supplied with the 6mm CR fitted in place with the 4mm loop ready for assembly. If I ship them assembled then there is a chance of the 4mm CR being damaged in transit.

Check Out The Instructions For This Electrode

Note: This product is supplied as is and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings, the printed product will show some layer lines and require a light sanding.