I have designed a 3D printable anal Monopole Conductive Rubber Electrode that I am calling my Anal T.

Each Anal T Electrode will be printed in my trademark YELLOW PLA. This insulator comes with 10"/25cm of 6mm conductive rubber tubing that takes 2mm plugs.

One side of the Conductive Rubber loop has a pin fitted to secure it in place. Your TENS cable plug secures the other end; you can remove this plug to allow two plugs to attach to this electrode from different channels if you are using a Tri-phase set-up to make it the base connector.

Just plug in your 2mm plug and then insert it into your anus before switching on your control box and experiencing some e-stim pleasure. Its shape makes long-term wear comfortable as it nestles between your cheeks comfortably.

I recommend that you paint it first, though to seal the surfaces with a plastic paint such as Krylon Fusion For Plastic.

Note: This product is supplied as is, and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings, the printed product will show some layer lines and require a light sanding.